The emergence of palletizing robot is based on the high-tech development of robot. It can imitate some action functions of the arm, and is used to capture, carry objects or operate tools according to fixed procedures. Stacking and handling is a very difficult task. People often affect production plans due to lack of physical strength. In order to ensure the production needs of enterprises, palletizing robots came into being.
Common faults of stacking robot.
What is the matter that the clamping action of the stacking robot is too slow or the clamping travel is insufficient? The user can check whether the bolt is loose, and whether the front buckle or the internal plate of the trigger is worn. Tighten the bolts and pay attention to the correct position of the front buckle shaft. The front buckle or the internal plate of the trigger can be replaced. After completing the above actions, test its function. If the stroke is too short, fine tune the front axle buckle up; if the stroke is too slow, fine tune the front axle buckle down.
How to deal with air outlet leakage? The user can check whether the on-off valve ring is damaged, whether the switch seat ring is damaged, or whether the piston ring is damaged. If damaged, replace the ring.
How to deal with piston rod leakage? In this case, the bottom ring of the main body of the stacking robot is damaged and needs to be replaced.
The above is a common fault machine solution for small stacking robots, which may be helpful to you. In the daily production process, if the stacking robot fails, it can be investigated according to the above methods. If the problem cannot be controlled in time, the robot manufacturer can be contacted to obtain effective solutions to ensure the normal operation of the production line.
